Epson Stylus Pro 10000 Series 조립 설명서 - 페이지 8

{카테고리_이름} Epson Stylus Pro 10000 Series에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Pro 10000 Series 12 페이지. Auto take-up reel unit
Epson Stylus Pro 10000 Series에 대해서도 마찬가지입니다: 사양 (6 페이지), 제품 정보 (16 페이지), 설치 매뉴얼 (26 페이지), 빠른 설치 매뉴얼 (34 페이지), 빠른 참조 매뉴얼 (12 페이지), 보증 (28 페이지), 빠른 참조 매뉴얼 (12 페이지), 사양 (4 페이지), 사양 (1 페이지), 사용자 설명서 (13 페이지)

페이지 인쇄
Epson Stylus Pro 10000 Series 조립 설명서
2. Lock the two casters (A) and extend the two
stabilizer knobs (B) underneath the base unit.
A
3. Lift the printer unit by the eight hand grips
shown below. Then insert the printer unit into
the guide pins on the base unit.
c
Caution:
Do not attempt to lift the printer unit with
fewer than four people.
Note:
When you place the printer on the base unit, match
the right end square of the printer (shown as 4 inthe
illustration below) to the square of the same part of
the base unit.
5
B
4. Screw the two wing nuts (C) into the left and
5. Release the front casters and the stabilizer
6. Remove the protective materials:
D
E
7. Close the lower cover.
top view
right joint holes at the side-inner of the base
unit, and tighten them.
C
knobs and move the printer to the place of use
(a short distance away). Lock the casters and
extend the stabilizer knobs after moving.
D:
from the lower cover (tapes).
E:
from the platen (tapes).
F:
from the side of the print head compartment
(fixing metal plate inside the lower cover).
c
Caution:
Watch your fingers when opening and
closing the lower cover.
C
F