Epson Stylus Pro 10000 Series 조립 설명서 - 페이지 6

{카테고리_이름} Epson Stylus Pro 10000 Series에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Pro 10000 Series 12 페이지. Auto take-up reel unit
Epson Stylus Pro 10000 Series에 대해서도 마찬가지입니다: 사양 (6 페이지), 제품 정보 (16 페이지), 설치 매뉴얼 (26 페이지), 빠른 설치 매뉴얼 (34 페이지), 빠른 참조 매뉴얼 (12 페이지), 보증 (28 페이지), 빠른 참조 매뉴얼 (12 페이지), 사양 (4 페이지), 사양 (1 페이지), 사용자 설명서 (13 페이지)

페이지 인쇄

Assembling the base unit

Caution:

Have two people working on either side to

assemble the base unit (26 kg).

1. Hold base upright left (A) and a horizontal

strut as shown. Then fix the strut to the base

using the two M6 × 30 hex socket head bolts

(B) with the hex wrench.

Note:

An instruction sticker about the setting paper

basket is attached to the side of a horizontal

strut. Attach the strut front so that you can

read the instructions.

Do not fasten the screws too tight. Leave a

room to adjust the position when you fasten

the screw on the other base upright.

2. Referring the Step 1, fix the other strut to the

base.

3. Hold the base upright left (C) as shown below,

fix the two struts to the base using the four M6

× 30 hex socket head bolts (D) with the hex

wrench.

4. Fasten eight screws on the both sides of the

base upright securely.

This completes assembly of the base unit. Before

attaching the paper basket, mount the printer on

the base unit.

Assembling the Printer

Unpacking the printer unit

1. Open the box containing the printer unit and

remove the accessory box (E), the polystyrene

foam (F), and roll paper spindles (G).

2. Lift the box up and away from the printer unit,

then fold it and set aside. Also remove the

document box (H) and ink accessory kit (I).

Caution:

The printer unit is heavy and unwieldy. Have

two people unpack the printer unit, and four

people place the printer unit on top of the base

unit.