Toshiba E-Studio 6506AC Manual de preparación del papel - Página 22

Navegue en línea o descargue pdf Manual de preparación del papel para Impresora todo en uno Toshiba E-Studio 6506AC. Toshiba E-Studio 6506AC 46 páginas.

Loading Paper on the Bypass Tray

0.
When you make copies on OHP film, sticker labels, envelopes, Thick 4 paper, or non-standard size paper, load the
copy paper on the bypass tray. Using the bypass tray is also recommended for copying or printing on standard size
paper which is not set in any of the drawers.
Be careful not to cut your fingers when fanning.
This could injure you.
 The height of the paper must not exceed the indicator on the side guides. The maximum number of sheets varies
depending on the paper type. For details, refer to the Specifications Guide.
 When you use more than one sheet of paper, fan the sheets well before placing them on the bypass tray. Otherwise,
the sheets may not be separated before being fed.
 Do not push paper into the entrance of the bypass feeder. This could cause a paper misfeed.
 When you print on sheets of OHP film, remove the copied OHP film one sheet at a time as they exit onto the
receiving tray. If the sheets of OHP film pile up, they may get curled and may not be projected properly.
If you place the originals on the ADF for bypass copying and do not set the paper size, the originals will be copied
upside down. Be sure to set the paper size when you wish to do bypass copying.
1
Open the bypass tray.
If the paper is large, pull out the paper holder.
2
If you pull out the paper holder at the position of aligning the guideline to paper size to set, you can appropriately
increase the width of the paper holder.

22 Loading Paper on the Bypass Tray