Toshiba TDP-MT700 Manual del usuario - Página 20

Navegue en línea o descargue pdf Manual del usuario para Proyector Toshiba TDP-MT700. Toshiba TDP-MT700 34 páginas. Home theater projector
También para Toshiba TDP-MT700: Manual del usuario (36 páginas), Manual de servicio (49 páginas)

Imprimir página
Toshiba TDP-MT700 Manual del usuario

Using the projector and remote control

Preparations

1.
Turn all of the connected equipment on.
2.
Remove the lens cap.

Turning the power on

Follow the steps below.
1.
Make sure the Power light is orange after power has been applied
and the main AC power switch is turned on.
2.
Press and hold the ON/STANDBY button on the projector or
remote control to turn the projector on.
The ON/STANDBY button may not work while the projector is warning up.
3.
The fans will be up and running. A start-up image shows on the
screen for a few seconds.
4.
"Searching...." will be displayed on the screen before the projec-
tor identifies the input signal. This message will remain on the
screen until a valid signal is detected.
5.
If the horizontal frequency of the input signal exceeds the range of the projector, a message
reading " Unsupported timing" will be displayed on the screen. This message will remain on-
screen until you change the input signal.

Switching input signals

The projector can be connected to multiple equipment at the same
time. To sequentially select input signals, press one of the INPUT but-
tons on the remote control or INPUT on the projector.
When the projector is turned on, it will search for the input source
you last selected.
If you need to use the PIP or POP function, refer to
advanced operation.
20
Using the projector and remote control
3.
Plug the supplied power cord into the AC inlet on
the rear of the projector and turn the main AC
power switch on.
4.
Plug the power cord into a wall socket and turn
the wall switch on.
for
p.23