MSI MPG X570S Carbon EK X Manual del usuario - Página 9
Navegue en línea o descargue pdf Manual del usuario para Hardware informático MSI MPG X570S Carbon EK X. MSI MPG X570S Carbon EK X 11 páginas. Monoblock
Imprimir página
PVC WASHER
AM4 Backplate
M2.5x5 AX1 SCREW
M3x10 DIN7984
BACKPLATE
INSULATOR
STEP 1
IMPORTANT:
USE THIS OPENING AS
AN INLET PORT!
STEP 2
ATTACHING BLOCK ON THE MOTHERBOARD
STEP 1
Prior to fastening the screws please make sure the mounting holes on the
motherboard's circuit board are aligned with the water block.
Mosfet part: Use three (3) M2.5 x 5 AX1 Screws with PVC washers. Tighten the
screws evenly. Do not use excessive force when tightening the screws.
CPU part: Use four (4) M3 x 10 DIN 7984 with screws. Tighten the screws using
enclosed 2mm Allen Key.
Do not forget install the Backplate Insulator and AM4 Backplate (as
shown on the photo).
STEP 2
For the EK-Quantum Momentum X570 Aorus Master series water block to
operate properly the G1/4 port nearest to the right edge of the water block
MUST BE USED AS THE INLET PORT.
EK recommends the use of EK-Fittings. When using fittings other than EK series
please use hose clamps or appropriate substitute to secure the tubing to the
barb. The use of biocide containing and corrosion inhibiting coolant is always
recommended for any liquid cooling system.
- 9 -