- ページ 9

コンピュータ・ハードウェア MSI MPG X570S Carbon EK XのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。MSI MPG X570S Carbon EK X 11 ページ。 Monoblock

PVC WASHER

AM4 Backplate

M2.5x5 AX1 SCREW

M3x10 DIN7984

BACKPLATE

INSULATOR

STEP 1

IMPORTANT:

USE THIS OPENING AS

AN INLET PORT!

STEP 2

ATTACHING BLOCK ON THE MOTHERBOARD

STEP 1

Prior to fastening the screws please make sure the mounting holes on the

motherboard's circuit board are aligned with the water block.

Mosfet part: Use three (3) M2.5 x 5 AX1 Screws with PVC washers. Tighten the

screws evenly. Do not use excessive force when tightening the screws.

CPU part: Use four (4) M3 x 10 DIN 7984 with screws. Tighten the screws using

enclosed 2mm Allen Key.

Do not forget install the Backplate Insulator and AM4 Backplate (as

shown on the photo).

STEP 2

For the EK-Quantum Momentum X570 Aorus Master series water block to

operate properly the G1/4 port nearest to the right edge of the water block

MUST BE USED AS THE INLET PORT.

EK recommends the use of EK-Fittings. When using fittings other than EK series

please use hose clamps or appropriate substitute to secure the tubing to the

barb. The use of biocide containing and corrosion inhibiting coolant is always

recommended for any liquid cooling system.

- 9 -