Epson WorkForce 600 Series Manual de instalación en red - Página 34

Navegue en línea o descargue pdf Manual de instalación en red para Software Epson WorkForce 600 Series. Epson WorkForce 600 Series 41 páginas. Using the control panel for wireless network installation
También para Epson WorkForce 600 Series: Manual del usuario (34 páginas), Manual del usuario (38 páginas), Sustitución de cartuchos (2 páginas), Información importante sobre la instalación (2 páginas), Especificaciones (2 páginas), Manual Start Here (9 páginas), Boletín de asistencia sobre productos (5 páginas), Manual de funciones (28 páginas)

Epson WorkForce 600 Series Manual de instalación en red
Cannot communicate on a wired LAN
Make sure that the wireless setting on the printer's control panel is set to
Select
Setup
, and select
LAN Setup
communicate using a wired connection.
The printer does not appear in the Add Printer window (Mac OS X)
Make sure the printer driver was installed correctly and that your computer's
TCP/IP settings are configured correctly.

Printing Problems

Cannot print over the network
Print a Network Status Sheet (see page 36) and verify that the network
settings are correct.
Make sure that the printer is turned on, and that your router, access point,
switch, or hub's link LED for the port the printer is connected to is on or
flashing. If the link LED is off, try the following.
Make sure the Ethernet cable is securely connected to both the printer
and your router, access point, switch, or hub.
Try connecting to another port on your router, access point, switch, or
hub.
Try connecting the printer to another router, access point, switch or hub.
Try connecting the printer to your router, access point, switch, or hub
with another Ethernet cable.
When using TCP/IP, make sure the printer's IP address is set correctly for your
network. If your network does not assign IP addresses using DHCP, you will
need to set the IP address manually.
For wired connections, print a Network Status Sheet (see page 36). If the
Network Status says Disconnect, check your Ethernet cable connections and
try turning the printer off and back on again.
For wireless connections, print a Network Status Sheet (see page 36). If the
Link Status says Disconnect, make sure that the wireless router or access point
is turned on and that the settings are correct for your wireless network.
34
Troubleshooting
from the Home menu, select
Disable
Network Settings
. If it is set to
Enable
, choose
Wireless
, the printer will not
.
Disable