CRU Dataport DataPort 525 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Recinto CRU Dataport DataPort 525. CRU Dataport DataPort 525 13 páginas. Usb 2.0 and firewire enclosure

Imprimir página

NSTALLING THE

ARD

ISK

1. Remove the four screws in the corners on the back of the

enclosure.

2. Slide the covers up and away from the back of the enclosure.

3. On the top is a metal cover. On the end there are two indents;

grip them with your fingers and pull the metal cover off towards

the rear of the enclosure (see Diagram 8).

4. To install a hard drive, lower the drive into the enclosure. Plug

the data cable into the drive. Plug the power cable into the

drive. Fasten the drive to the bottom of the enclosure with the

4 provided screws (see Diagram 9).

5. To install a 5 1/4" device such as a CD Drive, remove the front

face plate on the enclosure by snapping it out from the inside.

Plug the cable from the audio jacks into the drive. Plug the 40-

pin data cable into the drive. Plug the power cable into the

drive. Fasten the drive to the enclosure via the 4 side mount-

ing holes using the provided screws.

6. Slide the covers back on and snap them into place. Re-install

the four screws in the back of the enclosure (see Diagram 10).

7. Connect the USB/Firewire cable from the computer's FireWire

or USB port to the enclosure.

8. Plug the provided power cable into the back of the enclosure.

Diagram 8

WWW.CRUINC.COM • (800) 260-9800

(DP525)

RIVE

Diagram 9

Diagram 10