Pioneer A-656 Manual de instrucciones - Página 11
Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Pioneer A-656. Pioneer A-656 13 páginas.
También para Pioneer A-656: Manual de instrucciones (14 páginas)
Imprimir página
SPECIFICATIONS
[A-757]
Continuous
power output (both channels
driven at 20 Hz to
20 kHz) **
U.S., Canadian models
Continuous
Average
Power
Output
is 100
Watts** per channel, min., at 8 ohms from 20
Hertz
to 20,000
Hertz,
with
no
more
than
0,003% total harmonic distortion.
*** Measured
pursuant
to
the
federal
Trade Commission's Trade Regulation
rules
on
Power
Output
Claims
for
Amplifiers.
FTC continuous power output (both channels driven)
20 Hz to 20 kHz, T.H.D. 0.003%,
8Q ----+--
100W + 100W*
20 Hz to 20 kHz, T.H.D. 0.005%, 4 Q --+++--
135W + 135W*
U.K, model
T.H.D, 0.003%, 8 Q
T.H.D. 0.005%, 4 Q
Other destination models
T.H.D, 0,003%, 8 Qsssereee
100W + 100W*
T.H.D. 0.005%, 4 Q
sess
140W + 140W*
DIN continuous power output (both channels driven)
U.K, model
S5W + 95W*
++ 140W + 140W*
1 KHz, T.H.D. 1.0%, 8 Qerrerseeee
s e r e
TOOW + 100W
1 kHz, T.H.D. 1.0%, 4 Qseeeeeeeee
«+++ 150W
+ 150W
Total harmonic distortion **
U.S., Canadian models
20 Hz to 20 KHz, 100W, 8 Q verter reer reer trees
0.003% *
20 Hz to 20 kHz, 135W, 4 Q ---++eree sai
ajie inte ++ 0.005% *
U.K. model
20 Hz to 20 kHz, 95W,8Q
---
0.003% *
20 Hz to 20 kHz, 140W, 4 Q --
0.005% *
Other destination models
20 Hz to 20 kHz, 100W, 8 Q +-++++++
+ 0.003% *
20 Hz to 20 kHz, 140W, 4 Q verre
reer reece eeeee ee 0.005% *
The followings are applicable to ail models.
Power bandwidth
0.05%,
82
ater
e eee
sean
e eee
tena
e ewes
5 Hz-—70
kHz*
Damping factor
{1 kH2/20 Hz to 20 kHz), 8 Qe- essere eee eee eer enee 200/70
Dynamic power output (on EIA dynamic test signal)
4Q]22
+++ 2OOW/300W
Inter-modulation distortion (at rated output) -
0.003% *
input sensitivity/impedance
PHONO (MM) -
2.5 mV/50 kQ
PHONO
(MC) ++ seer ee
0.2 mV/100 Q
CD, TUNER, LINE, TAPE
PHONO overload level
- 150 mV/50 kQ
1 kHz, T.H.D. 0.008% (MM/MC)
++++++---+- ++ 200 mV/19 mV
Output level/impedance
TAPE REC, ADAPTOR OUTPUT :------++>-
150 mV/2.2
kQ
Frequency response
PHONO (MM), 20 Hz to 20 kHz ---
PHONO (MC), 20 Hz to.20 kKHz--:-
CD, TUNER, LINE, TAPE (1 Hz to 150 kHz) --
-+ £0.246B
+ $0.3¢dB
. ype
+ ap
Tone control (volume contro! set at -40 dB position)
BASS -
aia
'
TREBLE -
Loudness contour (volume control set at -40 dB position)
Sette eesercesesconeceeensees +5 dB (100 Hz)/+3 dB (10 kHz)
Filter (GUBSONIC)++
+++ 0e essere seen ee er eee 17 Hz (12 dBjoct.)
Signal-to-Noise ratio (IHF short circuit, A network)
PHONO (MM, 5 mV input/MC, 0.5 mV input)
+ 95 dB/77 dB*
110 dB*
CD, TUNER, LINE, TAPE
Signal-to-Noise ratio (DIN, continuous power/50 mW)
PHONO (MM)
+ 74 dB/65 dB*
CD, TUNER, LINE, TAPE
+ 92 dB/68 dB*
Power Supply/Miscellaneous
Power requirements
U.S., Canadian models:+++++++ertrerree eee AC 120V, 60 Hz
U.K., Australian models
-
-a.c, 240 Volts ~, 50/60 Hz
Other destination models -+++++eesrreeerereeteeeeeeeensees
~AC110V/120 — 127V, /220V/240V (switchable), 50/60 Hz
Power consumption
U.S., Canadian models
U.K., Australian models -
Other destination models
AC outlets
switched (X 2) vrreeeeeeeeeeeeeeeereeseees
unswitched (X 1)++++erees
Dimensions ++++++++eeereer eee 420 (W) x 435 (D) x 162 (H) mm
16-9/16 (W) X 17-1/8 (D) x 6-3/8 (H) in
Weight (without package) :---+--+ +++ trerseeeess e+ 19,5 kg (43 Ib)
Accessories
Operating instructions -++++++
Cushion spacer set --+ ++ saiepaie
ts as
NOTE:
Specifications and design subject to possible modification without
notice, due to improvements.
*
When the DIRECT switch to ON,
**
Measured by Audio Spectrum Analyzer.
Be sure to place the unit on a level surface so that it stands
firmly on all its feet. If wobbly, adjust by attaching the supplied
cushion spacers to one or more feet.
Cushion spacers ——=—- Peel off protective paper
S
11
<ARB1175>
E