Aeotec Smart Switch 7 Manual - Página 14
Navegue en línea o descargue pdf Manual para Interruptor Aeotec Smart Switch 7. Aeotec Smart Switch 7 18 páginas.
También para Aeotec Smart Switch 7: Manual del usuario (8 páginas), Manual (6 páginas)
Imprimir página
(2) Different protection trigger
Protection trigger
Local Protection
RF Protection
Alarm Report
Over-current detected
Over-load detected
AEOTEC Engineering Specification
Activation condition
Protection Set:
Local Protection State = 2
Protection Set:
RF Protection State = 1
Receive any alarm enabled by
Alarm Settings (Parameter 9)
The
current
of
the
connected is over 11A.
The
power
of
the
connected
is
over
threshold value.(Parameter 4)
Result
No operation possible. It is not
possible at all to control a device
directly via the user interface.
No
RF control
-
Commands are ignored by the
device.
(1)Switch will react based on
Alarm Response (Parameter 8),
and Indicator Light will keep
blinking based on Parameter 18.
(2)Local Protection State will NOT
automatically change to be 2.
However, it is not possible at all to
control a device directly via the
user
interface
until
disable.
(3)RF Protection State will NOT
automatically change to be 1.
However,
Switch
Application
Rejected
when
receives
any
which can control the switch state
until alarm is disable.
(1)Blinking red light.
(2)Turn off switch.
(3)Local
Protection
automatically change to be 2. It is
not possible at all to control a
device
directly
via
interface until users set the Local
Protection
State
load
0(unprotected).
(4)RF
Protection
automatically change to be 1.
Switch will report Application
Rejected Request when receives
any command which can control
the switch state until users set the
RF
Protection
State
0(unprotected).
(1)Blinking red light.
(2)Turn off switch.
(3)Local
Protection
automatically change to be 2. It is
not possible at all to control a
device
directly
via
interface until users set the Local
load
Protection
State
the
0(unprotected).
(4)RF
Protection
automatically change to be 1.
Switch will report Application
Rejected Request when receives
any command which can control
the switch state until users set the
RF
Protection
State
0(unprotected).
Page 9
How to cancel/disable
Protection Set:
Local Protection State = 0
all runtime
Protection Set:
RF Protection State = 0
Based on the setting to
disable alarm (Parameter
10).
alarm
is
Note:
Power off will also disable
the alarm response without
any limitation.
will
report
Request
command
State
will
the
user
to
be
Protection Set:
Local Protection State = 0
State
will
RF Protection State = 0
to
be
State
will
the
user
to
be
Protection Set:
Local Protection State = 0
State
will
RF Protection State = 0
to
be