Aeotec Smart Switch 7 Manual - Página 17

Navegue en línea o descargue pdf Manual para Interruptor Aeotec Smart Switch 7. Aeotec Smart Switch 7 18 páginas.
También para Aeotec Smart Switch 7: Manual del usuario (8 páginas), Manual (6 páginas)

Imprimir página

Can be disabled by 3x tapping Action Button within 1 second

Can be disabled when receives a State Idle corresponding to the alarm .

Note: If Access Control is enable, it also can be disabled when receives

the reversal state of window/door.

10..255 Sets the duration of the alarm in seconds(i .e. Customer sets this setting

to 50, the alarm state of the Switch will disable after 50 seconds)

Note:

Power off will also disable the alarm response without any limitation.

0x12(18)

LED blinking frequency.

Value

Description

1..9

Set amount of blinks per seconds.

Note:

When receiving the enable Alarm, it will flash according to the blink frequency

configured by this parameter until the Alarm is disable. Brightness level and color

is based on current indicator. If the value of brightness level and color is 0, it will

flash based on last visible color.

0x13(19)

Start or stop LED blinking.(Write Only)

Value

Description

Stop blinking.

1..255

Set the duration and start the blinking process .

* This sets the timeframe of blinking in seconds .

* Once the duration ends, the blinking will stop .

Note:

The parameter can be used to test the effect of LED blinking.

0x14(20)

Action in case of power out.

Value

Description

Last status

Switch is on

Switch is off

0x50(80)

Configure what command will be sent via Lifeline when switch state has changed.

Value

Description

None

Basic Report

Binary Switch Report

0x51(81)

Load Indicator Mode setting .

Value

Description

Disable Mode.

* LED will only illuminate for network removal, press and hold Action

Button.

* No other LED reaction for load status.

* Will allow LED blinking frequency parameter setting to blink the LED.

* Brightness level can NOT be configured via Multilevel Switch CC.

* Color can NOT be configured via Color Switch CC.

* Will report Application Rejected Request when receives Multilevel

Switch CC or Color Switch CC.

Night Light Mode.

* During enable time, 100% Red is the default color and can be

changed.

* During disable time, OFF is the default color and can be changed.

* Enable and disable time are defined by Parameter 0x52(82).

* Brightness level can be configured via Multilevel Switch CC.

* Color can be configured via Color Switch CC.

ON/OFF Mode.

* ON status, 50% White is the default color and can be changed.

* OFF status, 10% Green is the default color and can be changed.

* Brightness level can be configured via Multilevel Switch CC.

* Color can be configured via Color Switch CC.

Note:

Configuring brightness and color of Indicator Light in different time/status of

different modes will be saved in the current setting mode .

0x52(82)

Configure the enable and disable time of Night Light Mode

AEOTEC Engineering Specification

Page 12

0x12000800 4