Whirlpool 7MWTW5010PW Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Lavadora Whirlpool 7MWTW5010PW. Whirlpool 7MWTW5010PW 32 páginas.
Imprimir página
INSTALLATION REQUIREMENTS
Tools and Parts
Gather required tools and parts before starting installation.
Tools Needed:
Adjustable or open end
wrench 9/16" (14 mm)
minimum
Wood block
Adjustable pliers that
open to 1¾" (45 mm)
Bucket
Parts Supplied:
NOTE: All parts supplied for installations are in the washer.
Drain hose with clamp, U-form,
and cable tie
Parts Needed: (if not supplied with washer)
Inlet hoses with flat washers
Level
Ruler or measuring tape
Flashlight
NOTE: The new hose-sets
supplied with the appliance are
to be used. Old hose-sets
should not be reused.
Alternate Parts: (not supplied with washer)
Your installation may require additional parts. To order, please
refer to the contact information referenced in your Quick Start
Guide.
If you have:
You will need:
Overhead sewer
Standard 20 gallons (76 L) 39" (990 mm)
tall drain tub or utility sink, sump pump,
and connectors (available from local
plumbing suppliers)
1" (25 mm) standpipe 2" (51 mm) diameter to 1" (25mm)
diameter standpipe adapter and
connector kit
Drain hose too short
Extension drain hose and connector kit
Lint-clogged drain
Drain protector and connector kit
Location Requirements
Select proper location for your washer to improve performance
and minimize noise and possible "washer walk." Install your
washer in a basement, laundry room, closet, or recessed area.
IMPORTANT: Do not install, store, or operate washer where it will
be exposed to weather or in temperatures below 32°F (0°C).
Water remaining in washer after use may cause damage in low
temperatures. See "Washer Maintenance and Care" for
winterizing information.
Proper installation is your responsibility.
You will need:
� A water heater set to 120°F (49°C).
� A grounded electrical outlet located within 4 ft (1.2 m) of power
cord on back of washer.
� Hot and cold water faucets located within 3 ft (0.9 m) of hot
and cold water fill valves on washer, and water pressure of
4.35-124.7 psi (0.03-0.86 MPa).
� A level floor with maximum slope of 1" (25 mm) under entire
washer. Installing on carpet or surfaces with foam backing is
not recommended.
� Floor must support washer's total weight (with water and load)
of 315 lbs (143 kgs).
Recessed area or closet installation
NOTE: All 27" (69 cm) wide washers should have 19" (48 cm)
clearance, while all 29" (74 cm) wide washers should have
22" (56 cm) clearance.
5