Whirlpool 7MWTW5010PW Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice Whirlpool 7MWTW5010PW. Whirlpool 7MWTW5010PW 32.

Stampa la pagina

INSTALLATION REQUIREMENTS

Tools and Parts

Gather required tools and parts before starting installation.

Tools Needed:

Adjustable or open end

wrench 9/16" (14 mm)

minimum

Wood block

Adjustable pliers that

open to 1¾" (45 mm)

Bucket

Parts Supplied:

NOTE: All parts supplied for installations are in the washer.

Drain hose with clamp, U-form,

and cable tie

Parts Needed: (if not supplied with washer)

Inlet hoses with flat washers

Level

Ruler or measuring tape

Flashlight

NOTE: The new hose-sets

supplied with the appliance are

to be used. Old hose-sets

should not be reused.

Alternate Parts: (not supplied with washer)

Your installation may require additional parts. To order, please

refer to the contact information referenced in your Quick Start

Guide.

If you have:

You will need:

Overhead sewer

Standard 20 gallons (76 L) 39" (990 mm)

tall drain tub or utility sink, sump pump,

and connectors (available from local

plumbing suppliers)

1" (25 mm) standpipe 2" (51 mm) diameter to 1" (25mm)

diameter standpipe adapter and

connector kit

Drain hose too short

Extension drain hose and connector kit

Lint-clogged drain

Drain protector and connector kit

Location Requirements

Select proper location for your washer to improve performance

and minimize noise and possible "washer walk." Install your

washer in a basement, laundry room, closet, or recessed area.

IMPORTANT: Do not install, store, or operate washer where it will

be exposed to weather or in temperatures below 32°F (0°C).

Water remaining in washer after use may cause damage in low

temperatures. See "Washer Maintenance and Care" for

winterizing information.

Proper installation is your responsibility.

You will need:

� A water heater set to 120°F (49°C).

� A grounded electrical outlet located within 4 ft (1.2 m) of power

cord on back of washer.

� Hot and cold water faucets located within 3 ft (0.9 m) of hot

and cold water fill valves on washer, and water pressure of

4.35-124.7 psi (0.03-0.86 MPa).

� A level floor with maximum slope of 1" (25 mm) under entire

washer. Installing on carpet or surfaces with foam backing is

not recommended.

� Floor must support washer's total weight (with water and load)

of 315 lbs (143 kgs).

Recessed area or closet installation

NOTE: All 27" (69 cm) wide washers should have 19" (48 cm)

clearance, while all 29" (74 cm) wide washers should have

22" (56 cm) clearance.