Whirlpool GZ5730XR Series Instrucciones de instalación y manual de uso y mantenimiento - Página 9

Navegue en línea o descargue pdf Instrucciones de instalación y manual de uso y mantenimiento para Campana de ventilación Whirlpool GZ5730XR Series. Whirlpool GZ5730XR Series 24 páginas. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood
También para Whirlpool GZ5730XR Series: Dimensiones (1 páginas), Instrucciones de instalación y manual de uso y mantenimiento (24 páginas), Instrucciones de instalación y manual de uso y mantenimiento (24 páginas), Instrucciones de instalación y manual de uso y mantenimiento (24 páginas)

6. Connect the power supply ground wire to the green ground

connector and tighten securely.

A. Green ground connector

7. Securely tighten the strain relief.

8. Replace the wiring cover.

UL-Listed Power Supply Cord Kit (U.S. Only)

1. Connect a UL-listed Power Cord Kit (part no. 99524057) (U.S.

only) following the kit instructions for connecting the wires.

2. Replace the wiring cover.

Install Range Hood

WARNING

Excessive Weight Hazard

Use two or more people to move and install range hood.

Failure to do so can result in back or other injury.

1. Remove the 4 hood mounting screws from the parts bag and

install in previously drilled ¹⁄₈" (3.0 mm) pilot holes. Leave

screw heads about ¹⁄₄" (6.4 mm) away from shim strips.

2. Lift range hood into final position, feeding electrical wire

through wiring opening. To avoid damage, do not push on fan

blade.

3. Position the range hood so that the large end of the keyhole

4. Tighten mounting screws to cabinet, making sure mounting

On vented installations:

5. Make sure that damper blade opens and closes freely.

6. Connect ventwork to hood. Seal joints with duct tape to make

1. Install (2) PAR20, 50W maximum halogen bulbs or (2) R16,

2. Replace filters.

3. Reconnect power.

4. Check for proper operation.

¹⁄₄

" (6.4 mm)

slots are over the screws. Then push the hood toward the wall

so that the screws are in the neck of the slots.

A. Keyhole slots (4)

B. Mounting screw

screws are in narrow neck of slots.

them secure and air tight.

40W maximum incandescent bulbs. Bulbs purchased

separately.

NOTE: Filter slot must be toward front of hood.

For non-vented installations: Attach the charcoal filters (not

supplied) to the aluminum filters with the special blue and

yellow strips facing toward the cooking surface. Make sure

fan blade turns freely.