Whirlpool GZ5730XR Series 설치 지침 및 사용 및 관리 설명서 - 페이지 9

{카테고리_이름} Whirlpool GZ5730XR Series에 대한 설치 지침 및 사용 및 관리 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool GZ5730XR Series 24 페이지. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood
Whirlpool GZ5730XR Series에 대해서도 마찬가지입니다: 치수 (1 페이지), 설치 지침 및 사용 및 관리 설명서 (24 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (24 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (24 페이지)

Whirlpool GZ5730XR Series 설치 지침 및 사용 및 관리 설명서
6. Connect the power supply ground wire to the green ground
connector and tighten securely.
A. Green ground connector
7. Securely tighten the strain relief.
8. Replace the wiring cover.
UL-Listed Power Supply Cord Kit (U.S. Only)
1. Connect a UL-listed Power Cord Kit (part no. 99524057) (U.S.
only) following the kit instructions for connecting the wires.
2. Replace the wiring cover.

Install Range Hood

WARNING
Excessive Weight Hazard
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
1. Remove the 4 hood mounting screws from the parts bag and
install in previously drilled ¹⁄₈" (3.0 mm) pilot holes. Leave
screw heads about ¹⁄₄" (6.4 mm) away from shim strips.
2. Lift range hood into final position, feeding electrical wire
through wiring opening. To avoid damage, do not push on fan
blade.
3. Position the range hood so that the large end of the keyhole
A
4. Tighten mounting screws to cabinet, making sure mounting
On vented installations:
5. Make sure that damper blade opens and closes freely.
6. Connect ventwork to hood. Seal joints with duct tape to make
1. Install (2) PAR20, 50W maximum halogen bulbs or (2) R16,
2. Replace filters.
3. Reconnect power.
4. Check for proper operation.
¹⁄₄
" (6.4 mm)
slots are over the screws. Then push the hood toward the wall
so that the screws are in the neck of the slots.
A
B
A. Keyhole slots (4)
B. Mounting screw
screws are in narrow neck of slots.
them secure and air tight.

Complete Installation

40W maximum incandescent bulbs. Bulbs purchased
separately.
NOTE: Filter slot must be toward front of hood.
For non-vented installations: Attach the charcoal filters (not
supplied) to the aluminum filters with the special blue and
yellow strips facing toward the cooking surface. Make sure
fan blade turns freely.
A
9