Firesense LIP-10A-TGG-NTS-1 Manual - Página 9

Navegue en línea o descargue pdf Manual para Calentador de patio Firesense LIP-10A-TGG-NTS-1. Firesense LIP-10A-TGG-NTS-1 17 páginas. Outdoor patio heater

Imprimir página

ASSEMBLY

6. Attach Head Assembly (C) to Main Post (D).

Note: There is a small piece of protective foam located in the

neck of the Head Assembly that MUST be removed prior to

attaching Head Assembly to the Upper Post.

Route Gas Hose (E) down into Main/Lower post assembly and

align 4 small holes on Head Assembly with 4 Small holes in Main

Post (F).

[HINT: Control knob should be above decal on post.]

Insert 4 M6x10 (FF) bolts through 4 M6 lock washers into holes and

tighten.

Hardware Used: 4 - M6x12 Bolt with Lock Washer

7. Assemble Reflector Panels (A) with Reflector Center Cap (B).Reflector

Panels (A) come packaged in two brown boxes with two panels in each

box. Hardware for assembly is already affixed to each panel. Place two

panels side by side and remove the two cap nuts and washers that are

affixed to one panel. Insert the affixed bolts into the open holes on the

adjacent panel. Place the washer over the bolt and screw on cap nut.

Repeat these steps until all four panels are assembled. Then locate the

Reflector Center Cap (B). You will need to remove the cap nuts and

washers located at the top of each Reflector Panel to allow assembly

of the Center Cap on each panel. Align the holes in the Center Cap with

the bolts on each panel and affix washer and cap nut to complete

assembly.