Firesense LIP-10A-TGG-NTS-1 Посібник - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник для Обігрівач для внутрішнього дворика Firesense LIP-10A-TGG-NTS-1. Firesense LIP-10A-TGG-NTS-1 17 сторінок. Outdoor patio heater
Друкувати сторінкуASSEMBLY
6. Attach Head Assembly (C) to Main Post (D).
Note: There is a small piece of protective foam located in the
neck of the Head Assembly that MUST be removed prior to
6
attaching Head Assembly to the Upper Post.
Route Gas Hose (E) down into Main/Lower post assembly and
align 4 small holes on Head Assembly with 4 Small holes in Main
Post (F).
[HINT: Control knob should be above decal on post.]
Insert 4 M6x10 (FF) bolts through 4 M6 lock washers into holes and
tighten.
Hardware Used: 4 - M6x12 Bolt with Lock Washer
7. Assemble Reflector Panels (A) with Reflector Center Cap (B).Reflector
7
Panels (A) come packaged in two brown boxes with two panels in each
box. Hardware for assembly is already affixed to each panel. Place two
panels side by side and remove the two cap nuts and washers that are
affixed to one panel. Insert the affixed bolts into the open holes on the
adjacent panel. Place the washer over the bolt and screw on cap nut.
Repeat these steps until all four panels are assembled. Then locate the
Reflector Center Cap (B). You will need to remove the cap nuts and
washers located at the top of each Reflector Panel to allow assembly
of the Center Cap on each panel. Align the holes in the Center Cap with
the bolts on each panel and affix washer and cap nut to complete
assembly.
9