Firesense 62232 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Calentador Firesense 62232. Firesense 62232 6 páginas. Alta halogen heater

Imprimir página
www.wtliving.com

OPERATION

Connect the power cable to a 120V, 12.5 amp supply that is located in a safe, dry area.
•
The pull-string switch is used to control the power of the appliance.
1.
Once the power is on, the PCB Hand Switch on the heater is used to
control the heat and light setting.
Press one (1) time: For Heating Element
Press two (2) times: For LED Lights
Press three (3) times: For LED Lights and Heating Element
Press four (4) times: Turn OFF LED Lights and Heating Element
2.
The Remote control is also used to control the heat and light settings:
Left Button: For Heating Element
Right Button: For LED Lights.
•
Although the patio heater is waterproof, do not use when raining or in
wet conditions.
•
Always disconnect the power cable from the electrical supply when the
patio heater is not in use.

CARE AND MAINTENANCE

•
Unplug the heater and let it cool completely.
•
To keep this unit clean, the outer shell may be cleaned with a soft, damp
cloth. You may use a mild detergent if necessary. After cleaning, dry the unit
with a soft cloth.
•
DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough
brushes to clean the heater. This may cause damage or deterioration to the
surface of the heater.
•
Although the heater is outdoor approved, DO NOT immerse the heater in
water for your safety.
•
Wait until the unit is completely dry before use.
•
Any maintenance or repairs including replacing the halogen tube should only
be carried out by a qualified electrician or by a recommended service center.
Contact us for assistance: (866) 985-7877 | www.wtliving.com
Warning: The
power cord cannot
be hung over the
heater head.
STORAGE
When not in use, store this unit in a cool,
dry location. To prevent dust and dirt
build-up, use the original packaging to
repack this unit.
TROUBLE SHOOTING
If this unit does not operate properly,
please check the following before repair
or service.
•
Check if the power cord is plugged
into an electrical outlet, if not, plug in.
•
Check if electricity to the main fuse is
working.
•
Make certain the power switches are
turned on. If not, choose a setting.
•
This heater has an internal sensor
that will sense if the heater is
overheating. If the heater stops
operation due to this device, please
check to see if the heater is placed
too close to objects causing it to
overheat and re-position the heater
for proper clearance. To restart the
heater, please wait about 5 minutes
after re-positioning and then reset
the switch of use the remote control.
TO RESET THE HEATER
•
Turn the heater off.
•
Unplug the heater.
•
When the heater thermostat
temperature lower than 40° C
or 104° F.
•
Plug in the unit again and operate
normally.

SPECIFICATIONS

•
Voltage Rating: 120V (60Hz)
•
Power Consumption: 1500W
•
Unit Weight: 14.8 kg / 32.63 lbs
•
Unit Size: 76cm / 29.92in x
62cm / 24.41in x 207-226.5cm
81.5-89.17in
5