Firesense 62232 Petunjuk Manual - Halaman 5

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Pemanas Firesense 62232. Firesense 62232 6 halaman. Alta halogen heater

Halaman Cetak

www.wtliving.com

OPERATION

Connect the power cable to a 120V, 12.5 amp supply that is located in a safe, dry area.

•

The pull-string switch is used to control the power of the appliance.

Once the power is on, the PCB Hand Switch on the heater is used to

control the heat and light setting.

Press one (1) time: For Heating Element

Press two (2) times: For LED Lights

Press three (3) times: For LED Lights and Heating Element

Press four (4) times: Turn OFF LED Lights and Heating Element

The Remote control is also used to control the heat and light settings:

Left Button: For Heating Element

Right Button: For LED Lights.

•

Although the patio heater is waterproof, do not use when raining or in

wet conditions.

•

Always disconnect the power cable from the electrical supply when the

patio heater is not in use.

CARE AND MAINTENANCE

•

Unplug the heater and let it cool completely.

•

To keep this unit clean, the outer shell may be cleaned with a soft, damp

cloth. You may use a mild detergent if necessary. After cleaning, dry the unit

with a soft cloth.

•

DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough

brushes to clean the heater. This may cause damage or deterioration to the

surface of the heater.

•

Although the heater is outdoor approved, DO NOT immerse the heater in

water for your safety.

•

Wait until the unit is completely dry before use.

•

Any maintenance or repairs including replacing the halogen tube should only

be carried out by a qualified electrician or by a recommended service center.

Warning: The

power cord cannot

be hung over the

heater head.

STORAGE

When not in use, store this unit in a cool,

dry location. To prevent dust and dirt

build-up, use the original packaging to

repack this unit.

TROUBLE SHOOTING

If this unit does not operate properly,

please check the following before repair

or service.

•

Check if the power cord is plugged

into an electrical outlet, if not, plug in.

•

Check if electricity to the main fuse is

working.

•

Make certain the power switches are

turned on. If not, choose a setting.

•

This heater has an internal sensor

that will sense if the heater is

overheating. If the heater stops

operation due to this device, please

check to see if the heater is placed

too close to objects causing it to

overheat and re-position the heater

for proper clearance. To restart the

heater, please wait about 5 minutes

after re-positioning and then reset

the switch of use the remote control.

TO RESET THE HEATER

•

Turn the heater off.

•

Unplug the heater.

•

When the heater thermostat

temperature lower than 40° C

or 104° F.

•

Plug in the unit again and operate

normally.

SPECIFICATIONS

•

Voltage Rating: 120V (60Hz)

•

Power Consumption: 1500W

•

Unit Weight: 14.8 kg / 32.63 lbs

•

Unit Size: 76cm / 29.92in x

62cm / 24.41in x 207-226.5cm

81.5-89.17in