Direct IP DC-E4213WRX Manual de instalación - Página 11
Navegue en línea o descargue pdf Manual de instalación para Cámara de seguridad Direct IP DC-E4213WRX. Direct IP DC-E4213WRX 18 páginas.
También para Direct IP DC-E4213WRX: Manual rápido (17 páginas)
Imprimir página
3
3
3
3
3
Plug in the network cable.
4
4
4
4
4
5
Connect the plug terminal to the RJ45 jack.
5
5
5
6
5
6
Push the waterproof cap body and cap into the RJ45
6
jack and rotate it.
6
6
Lock the waterproof cap into the waterproof cap
body.
Not pulling the cable back may cause water to seep in
and damage the product.
Installation
• Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall or
ceiling is not strong enough to support its weight.
• Install the camera in a shaded area. If the camera
is installed in direct sunlight, it may be affected
adversely.
1
Screw the mounting bracket to the wall or ceiling by
using screws(4) and bushings(4) provided with the
camera.
2
Adjust the camera angle by bending the stand. After
fully assembling the joint screws, unscrew it 2 ~
2.5 turns again and move the cover of the joints of
the left 3 places slightly. (The screws should not be
completely released to prevent it from falling.) After
adjusting the direction of the camera, turn the screw
clockwise to secure it completely.
M4
Screw
Part 1 – Introduction
11