3Com OfficeConnect WXR100 Manual de inicio rápido - Página 8
Navegue en línea o descargue pdf Manual de inicio rápido para Hardware de red 3Com OfficeConnect WXR100. 3Com OfficeConnect WXR100 10 páginas. Secure converged networks enterprise edition
También para 3Com OfficeConnect WXR100: Manual de inicio rápido (2 páginas), Manual del producto (15 páginas)
Imprimir página
8
M
S
S
OBILITY
YSTEM
Enter a DAP serial number, <cr> to exit:
success: created keypair for ssh
success: Type "save config" to save the
configuration
WX1200-aabbcc# save config
Optionally, enable Telnet and enable the admin user
6
to use Telnet.
WX1200-aabbcc# set ip telnet server enable
WX1200-aabbcc# set user wxadmin attr
service-type 6
Verify the configuration changes.
7
WX1200-aabbcc# display config
Save the configuration changes.
8
WX1200-aabbcc# save config
Preparing the Network for Distributed MAPs
A MAP that is not directly connected to a WX switch
is considered a Distributed MAP. Distributed MAPs
require the following support in order to find a WX
switch to configure and manage the MAP:
Power—Power over Ethernet (PoE) must be
provided on one of the Ethernet connections to
the MAP. Use a PoE injection device that has been
tested by 3Com. Providing PoE on both of the
Ethernet connections allows for redundant PoE.
DHCP—By default, a Distributed MAP uses IP for
communication, and relies on DHCP to obtain IP
parameters. Therefore, DHCP services must be
available on the subnet that the MAP is connected to.
Q
S
G
OFTWARE
UICK
TART
UIDE
DHCP must provide the following parameters to
the MAP:
IP address
Default router address
The DHCP server might also need to supply the fol-
lowing DNS parameters, unless the WX switch is in
the same subnet as the MAPs, or DHCP option 43
is used to supply a list of WX IP addresses or host-
names in the DHCP message.
Domain Name
DNS Server address
Static IP configuration—If DHCP is not available in
the network, a Distributed MAP can be configured
with static IP information that specifies its IP
address, as well as the WX switch uses as its boot
device. See the Wireless LAN Switch and Controller
Configuration Guide for more information.
DNS—If the intermediate network between the
WX switch and Distributed MAP includes one or
more IP routers, do one of the following:
Configure DHCP option 43 on the DHCP server
(see above).
Create a 3COMWX.mynetwork.com entry on
the DNS server.