3Com OfficeConnect WXR100 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} 3Com OfficeConnect WXR100에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com OfficeConnect WXR100 10 페이지. Secure converged networks enterprise edition
3Com OfficeConnect WXR100에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 제품 설명서 (15 페이지)

페이지 인쇄

OBILITY

YSTEM

Enter a DAP serial number, <cr> to exit:

success: created keypair for ssh

success: Type "save config" to save the

configuration

WX1200-aabbcc# save config

Optionally, enable Telnet and enable the admin user

to use Telnet.

WX1200-aabbcc# set ip telnet server enable

WX1200-aabbcc# set user wxadmin attr

service-type 6

Verify the configuration changes.

WX1200-aabbcc# display config

Save the configuration changes.

WX1200-aabbcc# save config

Preparing the Network for Distributed MAPs

A MAP that is not directly connected to a WX switch

is considered a Distributed MAP. Distributed MAPs

require the following support in order to find a WX

switch to configure and manage the MAP:

Power—Power over Ethernet (PoE) must be

provided on one of the Ethernet connections to

the MAP. Use a PoE injection device that has been

tested by 3Com. Providing PoE on both of the

Ethernet connections allows for redundant PoE.

DHCP—By default, a Distributed MAP uses IP for

communication, and relies on DHCP to obtain IP

parameters. Therefore, DHCP services must be

available on the subnet that the MAP is connected to.

OFTWARE

UICK

TART

UIDE

DHCP must provide the following parameters to

the MAP:

IP address

Default router address

The DHCP server might also need to supply the fol-

lowing DNS parameters, unless the WX switch is in

the same subnet as the MAPs, or DHCP option 43

is used to supply a list of WX IP addresses or host-

names in the DHCP message.

Domain Name

DNS Server address

Static IP configuration—If DHCP is not available in

the network, a Distributed MAP can be configured

with static IP information that specifies its IP

address, as well as the WX switch uses as its boot

device. See the Wireless LAN Switch and Controller

Configuration Guide for more information.

DNS—If the intermediate network between the

WX switch and Distributed MAP includes one or

more IP routers, do one of the following:

Configure DHCP option 43 on the DHCP server

(see above).

Create a 3COMWX.mynetwork.com entry on

the DNS server.