Xerox iGen3 Manual de planificación - Página 22
Navegue en línea o descargue pdf Manual de planificación para Software Xerox iGen3. Xerox iGen3 38 páginas. Solutions planning guide
También para Xerox iGen3: Folleto (8 páginas)
Imprimir páginaC.P. Bourg Document Finisher (BDFx)
Limitations
System Dependencies and Prerequisites
•
Due to the height of the bypass transport on DocuTech 1xx
HLC it is not possible to attach the BCFx without the BSR.
•
Requires a minimum of 2 skipped pitches (3 skipped pitches
with BCF), which results in low productivity with small
booklets. (A3/ 11 x 17 requires only one skipped pitch with or
without the BCF.)
•
The BDFx can only be guaranteed to work to its maximum
book thickness when feeding (8.5 x 11 / A4) paper if the
paperweight is 90 gsm or less. (Long grain paper with a
weight above 90 gsm should be tested with the customer
paper and application before selling the BDFx.)
•
Use of short grain paper is highly recommended for 11 x 17"
/ A3 sized paper.
Listed below are the dependencies and prerequisites for
installing the BDFx, BCFx and SQEDG module.
•
The printer must be equipped with a Bypass Transport to
enable In-line Finishing.
•
It is highly recommended that the printer is equipped with a
Bourg Sheet Rotator (BSR) to maximize output.
•
Due to the height of the bypass transport on DocuTech 1xx
HLC it is not possible to attach the BCFx without the BSR.
•
Requires a minimum of 2 skipped pitches (3 skipped pitches
with BCF), which results in low productivity with small
booklets. (A3/ 11 x 17 requires only one skipped pitch with or
without the BCF.)
3-2