Directed Xpresskit Solex Series Manual de instalación - Página 7
Navegue en línea o descargue pdf Manual de instalación para Accesorios para automóviles Directed Xpresskit Solex Series. Directed Xpresskit Solex Series 9 páginas.
Imprimir página
Platform: XK09
Firmware: DLPKKIA
Module Programming
RUN SAFE
When enabled, run safe will turn off the car engine if a door is opened. To disable run safe, press the UNLOCK button on
the remote. Run safe will auto-enable 45 seconds after all doors are closed, and it will also enable if a LOCK command is
sent. To perform take over, run safe must be disabled and the key must be inside the vehicle.
Note that for Type 4, Takeover is not possible. The vehicle will shut down if a door is opened.
Refer to the LED Diagnostics section on page 8 for more information and for troubleshooting purposes.
If connected in D2D:
Connect the 4-pin D2D and the 20-pin harnesses.
If connected in W2W:
Connect the 20-pin harness.
1
Caution! The 20-pin connector can be easily plugged in backwards.
The LED turns ON solid.
2
Connect one or both of the other 4-pin harnesses, depending on the
requirements of each installation types.
3
Make sure the key is inside the vehicle.
Press the Push-to-Start button twice to turn the ignition ON
4
pressing on the brake pedal. The LED will stay ON solid for 3
seconds, then turn OFF. For
ON for 3 seconds before turning OFF.
5
Press the Push-to-Start button once more to turn the ignition OFF.
The module is programmed and ready to use.
Resetting the Module
1
Disconnect the module from any power source.
2
Press and HOLD the Integrated Programming Button (IPB).
While holding the button, connect the module to the power source.
3
Wait until the red LED flashes once and release the Integrated Programming
Button (IPB).
The Mobile Integration Systems
Type 4
, the LED will flash, then turn
4-pin
20-pin
On Solid
4-pin
without
ENGINE
PUSH
START
STOP
Press 2x
Press & Hold
Flashes x1
© 2010 Directed Electronics. All rights reserved.
Rev.: 20101210
Page 7
Key Inside
the Vehicle
&
&
On x3 Secs
Off
ENGINE
PUSH
START
STOP
Press 1x
Disconnect from Power
&
Connect to Power
&
Release