Clarke 3120116 Instrucciones de uso y mantenimiento - Página 10
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Herramienta eléctrica Clarke 3120116. Clarke 3120116 17 páginas. Ratchet wrench
Imprimir página
9. Final tightening should be completed by hand to the required torque
settings.
DISCONNECTING THE AIR SUPPLY
1. DO NOT disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose from
the air tool.
3. Shut down the compressor at the end of the work session and drain daily as
recommended.
STORAGE
When not in use, disconnect from the air supply, clean & store in a safe, dry
place.
If the tool is to be stored or is idle for longer than 24 hours, run a few drops of
CLARKE air line oil into the air inlet and run the tool for 5 seconds in order to
lubricate the internal parts. When storing, replace the blanking plug on the
airline inlet.
Avoid storing the tool where the temperature is below 0
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10
o
C.