Clarke 3120116 Operating & Maintenance Instructions - Page 10

Browse online or download pdf Operating & Maintenance Instructions for Power Tool Clarke 3120116. Clarke 3120116 17 pages. Ratchet wrench

Print Page

9. Final tightening should be completed by hand to the required torque

settings.

DISCONNECTING THE AIR SUPPLY

1. DO NOT disconnect the air hose until the supply is isolated at a shut-off

valve.

2. Once the pressure has been isolated, disconnect the air supply hose from

the air tool.

3. Shut down the compressor at the end of the work session and drain daily as

recommended.

STORAGE

When not in use, disconnect from the air supply, clean & store in a safe, dry

place.

If the tool is to be stored or is idle for longer than 24 hours, run a few drops of

CLARKE air line oil into the air inlet and run the tool for 5 seconds in order to

lubricate the internal parts. When storing, replace the blanking plug on the

airline inlet.

Avoid storing the tool where the temperature is below 0

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]