Directed DIRECTECHS CHRYSLER10 Manual de instalación - Página 15
Navegue en línea o descargue pdf Manual de instalación para Alarma de coche Directed DIRECTECHS CHRYSLER10. Directed DIRECTECHS CHRYSLER10 19 páginas.
Imprimir página
Soft reset
A module reset will only erase the steps performed in "Module programming" on page 12. The firmware and settings flashed to
the module will not be affected.
If required for your installation, connect all the harnesses to the Directed Digital Solutions,
1
EXCEPT the 12-pin main power harness. Press and hold the programming button, then
connect the 12-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange then release the programming button.
2
The LED turns ON solid red.
Hard reset
Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings may need to
be reconfigured. Connect your module to a computer and use the web configuration tool to edit its programmable features.
If required for your installation, connect all the harnesses to the Directed Digital Solutions,
1
EXCEPT the 12-pin main power harness. Press and hold the programming button, then
connect the 12-pin harness to the module.
After 3 seconds the LED turns ON solid orange. Keep holding the programming button until
2
the LED flashes red, then orange slowly.
3
Release the programming button. The LED turns ON solid red.
15
Connect all but the
12-pin harness
&
&
Solid
Release
Solid
Connect all but the
12-pin harness
&
&
Solid
Hold
Flashes
&
Release
Solid
Directed Digital Solutions CHRYSLER10
© 2020-03-09 Directed. All rights reserved.