Directed DIRECTECHS CHRYSLER10 설치 매뉴얼 - 페이지 15

{카테고리_이름} Directed DIRECTECHS CHRYSLER10에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed DIRECTECHS CHRYSLER10 19 페이지.

Soft reset

A module reset will only erase the steps performed in "Module programming" on page 12. The firmware and settings flashed to

the module will not be affected.

If required for your installation, connect all the harnesses to the Directed Digital Solutions,

EXCEPT the 12-pin main power harness. Press and hold the programming button, then

connect the 12-pin harness to the module.

Wait 3 seconds until the LED turns ON solid orange then release the programming button.

The LED turns ON solid red.

Warning Against Executing a Hard Reset!

A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings may need to

be reconfigured. Connect your module to a computer and use the web configuration tool to edit its programmable features.

If required for your installation, connect all the harnesses to the Directed Digital Solutions,

EXCEPT the 12-pin main power harness. Press and hold the programming button, then

connect the 12-pin harness to the module.

After 3 seconds the LED turns ON solid orange. Keep holding the programming button until

the LED flashes red, then orange slowly.

Release the programming button. The LED turns ON solid red.

Connect all but the

12-pin harness

Solid

Release

Solid

Connect all but the

12-pin harness

Solid

Hold

Flashes

Release

Solid

Directed Digital Solutions CHRYSLER10