Directed DIRECTECHS CHRYSLER10 설치 매뉴얼 - 페이지 16

{카테고리_이름} Directed DIRECTECHS CHRYSLER10에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed DIRECTECHS CHRYSLER10 19 페이지.

Learning the Tach (not needed with Virtual Tach)

Tach comes preprogrammed, therefore learning is not required; however, it can be readjusted with the following operations:

1. Start the vehicle using the key.

2. Within 5 seconds, press and hold the Control Center (antenna) or the main module programming button, until the LED on the

Control Center (antenna) or the main module turns ON solid.

3. Release the button. The tachometer value is now stored in memory.

If the LED does not turn ON solid, find an alternate tach source.

Note: When the tachometer is programmed, the main module automatically enters the Tachometer engine checking mode.

To program Virtual Tach:

1. After the install is complete, remote start the engine. The programming operation may require 3 cranks of the starter before

the engine starts and runs. Do not turn off the remote start if this happens, it is a normal programming operation.

2. Once the engine begins running, let it run for at least 30 seconds.

3. Using the Remote, send the Remote start command to turn remote start off. Virtual Tach is programmed. To reset Virtual Tach, a

module reset must be done.

Note: Virtual Tach cannot be used in Manual Transmission Mode. It is also not recommended for diesel trucks.

Virtual Tach handles disengaging the starter motor during remote starting – it does not address over-rev. If the customer wants to

have the over-rev protection capability, the tach wire or data tach must be used.

Important! After successfully learning Virtual Tach, a small minority of vehicle starters may over crank or under crank during remote

start. Use the VirtualTach Fine tune feature in the configuration wizard to adjust the starter output time in 50mS increments to

compensate for such an occurrence.

Directed Digital Solutions CHRYSLER10