Directed DIRECTECHS CHRYSLER10 Manual de instalación - Página 4
Navegue en línea o descargue pdf Manual de instalación para Alarma de coche Directed DIRECTECHS CHRYSLER10. Directed DIRECTECHS CHRYSLER10 19 páginas.
Imprimir página
Introduction
The CHRYSLER10 firmware for Directed Digital Solutions is compatible with specific Chrysler vehicles. It is
a complete solution for remote start, security (if applicable), bypass interface, and convenience. This guide
provides information on the installation of the module using CHRYSLER10. If you would prefer using this system
as a digital solution, go to www.directechs.com and search for the make, model and year of the vehicle. This
will allow you to find the proper firmware and corresponding installation guide.
Warning! This module can only be programmed via the web tool, which can be found on www.directechs.com or using the
Directechs Mobile application for mobile devices. Features and functions will become accessible when you connect the module
using the XKLoader.
Pre-installation and application warnings
Firmware notes: This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
To remote start the engine, all doors must be closed, including rear hatch.
Key2GO is mandatory to control the immobilizer override in this firmware.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
Refer to the "Vehicle wiring reference chart" following each installation type.
General notes: This section highlights important information for this specific firmware.
The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin.
[1]
The siren is ONLY required when enabling the security features during module flashing.
[2]
The Comoft & Convenience Controls (CC) won't work if the vehicle is not equipped with heated seat features.
[3]
Additional parts required (maximum required):
6A Diode
0 x 1A Diodes
4
87
87a
86
85
30
0 x Relay
Keys required for
1
programming
Resistor 100Ω
0 x Resistor
Keys required for
0
operation
Fuse 7.5A
0 x Fuse
Directed Digital Solutions CHRYSLER10
© 2020-03-09 Directed. All rights reserved.