Clarke STRONG-ARM CSA20EP Manual de instrucciones de uso y mantenimiento - Página 3
Navegue en línea o descargue pdf Manual de instrucciones de uso y mantenimiento para Herramienta eléctrica Clarke STRONG-ARM CSA20EP. Clarke STRONG-ARM CSA20EP 17 páginas. 20 tonne hydraulic press
Imprimir página
SAFETY PRECAUTIONS
Due to the weight of the press, the help of an assistant will be beneficial during
assembly and installation.
ALWAYS operate the press with adequate light.
Before starting work, check for signs of cracked welds, loose or missing bolts, or
any other structural damage. Do not operate if any of these conditions exist.
Have repairs made only by authorised service centre.
NEVER tamper with any components. The safety valve is calibrated and
sealed at the factory; do not attempt to change the setting.
Use only the recommended hydraulic oil.
The components of this press are designed to withstand the rated capacity.
DO NOT substitute any other components or exceed the rated capacity of the
press.
Before applying pressure, ALWAYS ensure the workpiece is firmly secure and
stable.
ALWAYS clean up spills of hydraulic oil immediately as this can be dangerous in
a workshop environment.
DO NOT allow any person who is unfamiliar with hydraulic presses to use the
press unless they are under direct supervision.
DO NOT stand directly in front of the press when it is in use.
ALWAYS apply the load under the centre of the ram. Offset loads can
damage the ram and may cause the work piece to be ejected.
ALWAYS ensure the work piece is properly supported by the press bed.
When using accessories such as pressing plates, be certain they are centered
below the ram and are in full contact with the bed.
Parts being pressed may shatter or be ejected from the press. In the case of
varied applications, it is your responsibility to always use adequate guards,
and wear eye protection and protective clothing when using this press.
Keep hands and fingers away from parts that may pinch or shift.
NEVER use extension tubes to increase the length of the pump handle.
Excessive effort can cause damage and/or accidents.
Failure to heed these warnings may result in damage to the equipment, or
serious personal injury.
3
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]