Clarke 2092500 Manual de instrucciones de uso y mantenimiento - Página 11
Navegue en línea o descargue pdf Manual de instrucciones de uso y mantenimiento para Compresor de aire Clarke 2092500. Clarke 2092500 17 páginas. 150l engine driven air compressor
Imprimir página
TROUBLESHOOTING CHART
1. Any remedial work that may be required must be carried out by a qualified
electrician/engineer.
2. Empty Air Receiver of Air before dismantling any part of the compressor
unit's pressure system.
3. If your compressor develops a fault do not use until the fault has been
rectified.
SYMPTOM
Engine
difficult to
start
Compressor
unit
constantly 'on
load'
Unusual noise
from
compressor.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
IMPORTANT
PROBABLE CAUSE
Load Genie leaking
(compressor unit is on load
during start).
Load Genie valve blocked,
possibly frozen up.
Load Genie defective
Load Genie set at a pressure
higher than the safety valve's
opening pressure
Load Genie leaking.
Bolts loose.
Flywheel loose.
Unit installed on an unsuitable
base.
Bearings, piston rings or
cylinder worn.
Valve broken
!
REMEDY
Stop engine and empty air
receiver. Clean or replace
Load Genie
Thaw Load Genie out (Unit
must be installed in frost-
free place).
Have Load Genie serviced
or replaced
Contact Clarke Service
Department
Contact Clarke Service
Department
Tighten bolts
Tighten flywheel
Move unit to a more solid
base
Contact Clarke Service
Department
Contact Clarke Service
Department
11