Clarke 2092500 Manuel d'utilisation et d'entretien - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke 2092500. Clarke 2092500 17 pages. 150l engine driven air compressor
Imprimer la page
TROUBLESHOOTING CHART
1. Any remedial work that may be required must be carried out by a qualified
electrician/engineer.
2. Empty Air Receiver of Air before dismantling any part of the compressor
unit's pressure system.
3. If your compressor develops a fault do not use until the fault has been
rectified.
SYMPTOM
Engine
difficult to
start
Compressor
unit
constantly 'on
load'
Unusual noise
from
compressor.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
IMPORTANT
PROBABLE CAUSE
Load Genie leaking
(compressor unit is on load
during start).
Load Genie valve blocked,
possibly frozen up.
Load Genie defective
Load Genie set at a pressure
higher than the safety valve's
opening pressure
Load Genie leaking.
Bolts loose.
Flywheel loose.
Unit installed on an unsuitable
base.
Bearings, piston rings or
cylinder worn.
Valve broken
!
REMEDY
Stop engine and empty air
receiver. Clean or replace
Load Genie
Thaw Load Genie out (Unit
must be installed in frost-
free place).
Have Load Genie serviced
or replaced
Contact Clarke Service
Department
Contact Clarke Service
Department
Tighten bolts
Tighten flywheel
Move unit to a more solid
base
Contact Clarke Service
Department
Contact Clarke Service
Department
11