Zanussi ZEV6340FBA Manual del usuario - Página 10
Navegue en línea o descargue pdf Manual del usuario para Placa Zanussi ZEV6340FBA. Zanussi ZEV6340FBA 17 páginas.
También para Zanussi ZEV6340FBA: Manual del usuario (48 páginas)
Imprimir página
Problem
E6 comes on.
IF YOU CANNOT FIND A SOLUTION...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre. Give the data from the rating plate. Give
also three digit letter code for the glass ceramic (it
is in the corner of the glass surface) and an error
message that comes on. Make sure, you operated
INSTALLATION
WARNING! Refer to Safety chapters.
BEFORE THE INSTALLATION
Before you install the hob, write down the
information bellow from the rating plate. The rating
plate is on the bottom of the hob.
Serial number ...........................
BUILT-IN HOBS
Only use the built-in hobs after you assemble the
hob into correct built-in units and work surfaces
that align to the standards.
10
Possible cause
The second phase of the pow-
er supply is missing.
the hob correctly. If not the servicing by a service
technician or dealer will not be free of charge, also
during the warranty period. The instructions about
the Service Centre and conditions of guarantee are
in the guarantee booklet.
CONNECTION CABLE
•
The hob is supplied with a connection cable.
•
To replace the damaged mains cable use the
following (or higher) mains cable type:
H05V2V2-F T min 90°C. Speak to your local
Service Centre.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse, wait
one minute, and insert the fuse
again.