- ページ 10

ホブ Zanussi ZEV6340FBAのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZEV6340FBA 17 ページ。
Zanussi ZEV6340FBA にも：ユーザーマニュアル (48 ページ)

Problem

E6 comes on.

IF YOU CANNOT FIND A SOLUTION...

If you cannot find a solution to the problem yourself,

contact your dealer or an Authorised Service

Centre. Give the data from the rating plate. Give

also three digit letter code for the glass ceramic (it

is in the corner of the glass surface) and an error

message that comes on. Make sure, you operated

INSTALLATION

WARNING! Refer to Safety chapters.

BEFORE THE INSTALLATION

Before you install the hob, write down the

information bellow from the rating plate. The rating

plate is on the bottom of the hob.

Serial number ...........................

Only use the built-in hobs after you assemble the

hob into correct built-in units and work surfaces

that align to the standards.

Possible cause

The second phase of the pow-

er supply is missing.

the hob correctly. If not the servicing by a service

technician or dealer will not be free of charge, also

during the warranty period. The instructions about

the Service Centre and conditions of guarantee are

in the guarantee booklet.

•

The hob is supplied with a connection cable.

•

To replace the damaged mains cable use the

following (or higher) mains cable type:

H05V2V2-F T min 90°C. Speak to your local

Service Centre.

Remedy

Check if the hob is correctly

connected to the electrical

supply. Remove the fuse, wait

one minute, and insert the fuse

again.