Zanussi ZGG 643 Manual de instrucciones - Página 9
Navegue en línea o descargue pdf Manual de instrucciones para Placa Zanussi ZGG 643. Zanussi ZGG 643 11 páginas.
También para Zanussi ZGG 643: Manual de instrucciones (23 páginas)
Imprimir página
7. Building In
A = Auxiliary burner
R = Rapid Burner
These hobs can be inserted in a built-in kitchen unit
whose depth is between 550 and 600 mm. The hobs
dimensions are shown in Fig. 9.
The edge of the cut out must have a minimum distance
from the rear wall of 55 mm.
If there are side walls, or sides of the furniture unit near
the hob, the cut out edges must have a minimum
distance of 100 mm.
Hanging forniture units or hoods must be placed at 650
mm. minimum from the hob.
FITTING THE HOB TO THE WORKTOP
Before fitting the hob into the cut out, an adhesive seal
must be fitted to the underside outside edge (Fig. 9) of
the hob. It is essential that no gaps are left in this seal
in order to prevent spillage near the hob seeping into
the cabinet below.
1) Remove the pan supports, the burners caps and
crowns and turn the hob upside down, taking care the
ignition candles are not damaged in this operation.
2) Place the sealing gasket all around the glass top
edge as shown in Fig. 9.
3) Fit the hob in the cut out and push it down until the
glass top and the working top come in touch, as shown
in Fig. 10.
SR = Semirapid burner
SR
SR
R
FO 2034
FO 2108
Fig.9
FO 2107
Fig.10
A
Fig. 8
A
a) Sealing gasket