Aleko Victoria Series Manual de instalación - Página 11
Navegue en línea o descargue pdf Manual de instalación para Accesorios Aleko Victoria Series. Aleko Victoria Series 20 páginas. Sizes 6.5x5 8x6.5 10x8
También para Aleko Victoria Series: Manual de instrucciones de instalación y funcionamiento (12 páginas), Manual de montaje (14 páginas), Manual de instalación (17 páginas)
Imprimir página
- 1. Parts Diagram
- 2. Assembly Step One: Preparing Your Work Space
- 3. Assembly Step Four: Torsion Bar Assembly
- 4. Assembly Step Eight: Center Support Assembly
- 5. Installation: Notes about Wall Mounting
- 6. Optional Installation: Adjusting the Awning Pitch/Angle
- 7. Optional Installation: Motor Installation
2. Using a mallet, knock the round shaft cover (E-2) into the right roller support (E-1).
3. Now, link the roller support into the round shaft (F).
4. Use a wrench to tighten the roller support.
F-1
D-5
5. At this point, the roller tube and the roller support will be fully secured together, as shown on the diagram below.
STEP 10: Setting Awning Position
WARNING
secured to the torsion bar. Failure to check this could result in injury.
1. Move the blocker to the middle of the arms and fasten.
2. Then, move the arm bar link until the front bar wrist support is connected through it.
3. Align the front bar and the arm, and tighten the self locking nut upwardly with a screwdriver.
4. Then, tighten the adjustable bolt up to 90% tight using a ribbon tube spanner (as seen below).
Be sure that the safety sleeves holding the two front bar arms are
Insert in
Tighten
Steps 1 - 4
Steps 2 - 4
Step 5
Tighten
F
Insert in
E-1
E-2
Tighten
11