- ページ 11

アクセサリー Aleko Victoria SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Aleko Victoria Series 20 ページ。 Sizes 6.5x5 8x6.5 10x8
Aleko Victoria Series にも：設置および操作マニュアル (12 ページ), 組立マニュアル (14 ページ), インストレーション・マニュアル (17 ページ)

2. Using a mallet, knock the round shaft cover (E-2) into the right roller support (E-1).

3. Now, link the roller support into the round shaft (F).

4. Use a wrench to tighten the roller support.

F-1

D-5

5. At this point, the roller tube and the roller support will be fully secured together, as shown on the diagram below.

STEP 10: Setting Awning Position

WARNING

secured to the torsion bar. Failure to check this could result in injury.

1. Move the blocker to the middle of the arms and fasten.

2. Then, move the arm bar link until the front bar wrist support is connected through it.

3. Align the front bar and the arm, and tighten the self locking nut upwardly with a screwdriver.

4. Then, tighten the adjustable bolt up to 90% tight using a ribbon tube spanner (as seen below).

Be sure that the safety sleeves holding the two front bar arms are

Insert in

Tighten

Steps 1 - 4

Steps 2 - 4

Step 5

Tighten

Insert in

E-1

E-2

Tighten