Aleko BSW05 Manual de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de inicio rápido para Juegos infantiles y parques infantiles Aleko BSW05. Aleko BSW05 4 páginas. Double swing and glider playset

Imprimir página

Step 6. Insert 1 G9 Plastic Spacer into either side of the holes near the center of the

Glider Legs (Fig. 8).

Step 7. Attach the Glider Seat Tubes to either side of the Glider Legs by placing a G4

fastener through the same holes that the G9 Spacers have been installed in.

Step 8. Fasten Glider Seat to Glider Seat Tubes using 4 G7 Fasteners in both sets of

holes on both Seat Tubes. Repeat to assemble both Seats.

Step 9. Use G5 fasteners to secure Glider Footrest to lower holes in Glider Legs

Anchoring the Swing Set to the Ground

IMPORTANT: For safety reasons this gym MUST be anchored into the ground. We

recommend that it is concreted in. If you are uncertain about this procedure, telephone

our helpline number.

Step 1. Attach Ground Pegs to all 4 Swing Set Bottom Legs using P1 fasteners (Fig. 9).

Step 2. Place assembled Swing Set in desired location and dig a footing hole, measuring

12" (30cm) Long x 12" (30cm) Wide x 20" (50cm) Deep, at the base of each support leg.

Step 3. Prepare and pour concrete into the footing holes following concrete

manufacturer's instructions. Fully fill footing holes until level with ground surface.

Step 4. While Concrete is still wet, angle Ground Pegs toward opposing swing set legs at

roughly 120-degrees, then insert Ground Pegs into concrete footing, making sure Swing

set Bottom Legs do not sink below ground surface (utilize concrete set time information).

Use temporary support made from wood or other material if necessary to prevent sinking.

Swing Set will be ready for use once concrete is fully set and cured (consult concrete

manufacturer's instructions).

M6 BOLT 60mm (x4)

Fig. 9