Aleko BSW05 Manual de início rápido - Página 4
Procurar online ou descarregar pdf Manual de início rápido para Conjuntos de jogos & amp; Equipamento para parques infantis Aleko BSW05. Aleko BSW05 4 páginas. Double swing and glider playset
Imprimir página
Step 6. Insert 1 G9 Plastic Spacer into either side of the holes near the center of the
Glider Legs (Fig. 8).
Step 7. Attach the Glider Seat Tubes to either side of the Glider Legs by placing a G4
fastener through the same holes that the G9 Spacers have been installed in.
Step 8. Fasten Glider Seat to Glider Seat Tubes using 4 G7 Fasteners in both sets of
holes on both Seat Tubes. Repeat to assemble both Seats.
Step 9. Use G5 fasteners to secure Glider Footrest to lower holes in Glider Legs
Anchoring the Swing Set to the Ground
IMPORTANT: For safety reasons this gym MUST be anchored into the ground. We
recommend that it is concreted in. If you are uncertain about this procedure, telephone
our helpline number.
Step 1. Attach Ground Pegs to all 4 Swing Set Bottom Legs using P1 fasteners (Fig. 9).
Step 2. Place assembled Swing Set in desired location and dig a footing hole, measuring
12" (30cm) Long x 12" (30cm) Wide x 20" (50cm) Deep, at the base of each support leg.
Step 3. Prepare and pour concrete into the footing holes following concrete
manufacturer's instructions. Fully fill footing holes until level with ground surface.
Step 4. While Concrete is still wet, angle Ground Pegs toward opposing swing set legs at
roughly 120-degrees, then insert Ground Pegs into concrete footing, making sure Swing
set Bottom Legs do not sink below ground surface (utilize concrete set time information).
Use temporary support made from wood or other material if necessary to prevent sinking.
Swing Set will be ready for use once concrete is fully set and cured (consult concrete
manufacturer's instructions).
P1
M6 BOLT 60mm (x4)
5
35
35
5
Fig. 9
P1