Alemite 9949 Manual de servicio - Página 10

Navegue en línea o descargue pdf Manual de servicio para Bomba de agua Alemite 9949. Alemite 9949 14 páginas. High-pressure pump stripped and portable

Imprimir página

SER 9940

Pump Tube Assembly

Body

NOTE: Refer to Figure 4

for a section view of the

pump tube assembly.

1. Install and seat Seal (33) [heel end

first], Lantern Ring (34) [small end

first], Seal (35) [heel end first], and

Bearing (36) [small inside diameter

first] into Body (30).

2. Install O-Ring (29) onto the upper

groove of the Body.

Rod Assembly

3. Place Ball (42), Spring (41), and

Spring Guide (40) [pointed end first]

into the Piston.

4. Screw Extension (39) into the top of

the Piston until the pin holes align.

• Install Roll Pin (38).

5. Push on the Ball to ensure it operates

properly.

6. Screw Primer Rod (49) into Piston

(43) until the pin holes align.

• Install Roll Pin (44).

7. Screw Upper Rod (37) into the

Extension until the pin holes align.

• Install Roll Pin (38).

Pump Tube (Inner Components)

8. Install and seat Bearing (47), Seal (48)

[heel end first], and additional Bearing

(47) into the male threaded end of

Lower Tube (50).

9. Install and seat Gasket (46) into Tube

(45).

IMPORTANT: If a primer is

used with Loctite 222, the

c u r i n g t i m e i s g r e a t l y

reduced.

10. Screw the Lower Tube (with Loctite

222) into the Tube.

• Make sure the Gasket remains

seated.

• Do not tighten at this time.

Revision (2-03)

High-Pressure Pump (Stripped and Portable)

Refer to Figure 2-B Parts List

for Parts Identification

Figure 4 Pump Tube Assembly (w/o Air Motor) - Section View

Alemite Corporation