Clarke HIPPO 2 Instrucciones de uso y mantenimiento - Página 3
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Bomba de agua Clarke HIPPO 2. Clarke HIPPO 2 5 páginas. Submersible pump
También para Clarke HIPPO 2: Manual de instrucciones de uso y mantenimiento (13 páginas)
Imprimir página
Electrical Connections
HIPPO 2 - 240 Volt models:
(50Hz) electrical supply through an approved plug or a suitably fused isolator switch.
HIPPO 2 - 110 Volt models:
(50Hz) electrical supply through an approved plug or a suitably fused isolator
switch, or to a suitable portable 110 volt transformer.
We recommend that this pump is fitted with a Residual Current Device (RCD).
If the pump is to be connected to an outdoor electrical supply, make sure that both
the plug and the socket are of a British Standard approved waterproof design.
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow
As the colours of the flexible cord of this appliance may not correspond with the
coloured markings identifying terminals in your plug proceed as follows:
•
Connect GREEN & YELLOW cord to terminal marked with a letter "E" or Earth
symbol '
'or coloured GREEN or GREEN & YELLOW.
•
Connect BROWN cord to terminal marked with a letter "L" or coloured RED
•
Connect BLUE cord to terminal marked with a letter "N" or coloured BLACK
240 volt models only:
The fuse in the plug for this appliance must be rated at 13 amps.
If this appliance is fitted with a plug which is moulded onto the electric cable
(i.e. non-rewirable) please note:
1.
The plug must be thrown away if it is cut from the electric cable. There is a
danger of electric shock if it is subsequently inserted into a socket outlet.
2.
Never use the plug without the fuse cover fitted.
3.
Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code).
4.
Replacement fuse covers can be obtained from your local dealer or most
electrical stockists.
5.
The fuse in the plug must be replaced with one of the same rating (5 amps)
and this replacement must be ASTA approved to BS1362.
If in doubt, consult a qualified electrician.
Connect the mains lead to a standard 240 Volt
Connect the mains lead to a suitable 110 Volt
-
Earth
Blue
-
Neutral
Brown
-
Live
3