Alemite 3679 Manual de servicio - Página 3

Navegue en línea o descargue pdf Manual de servicio para Instrumentos de medida Alemite 3679. Alemite 3679 12 páginas. Electronic meter

Imprimir página

Electronic Meter

Installation

WARNING

Prior to installation, the following safety

precautions must be observed. Personal injury can

occur.

Do not exceed the pressure rating of any component

in the system.

Protect all fluid and air supply lines from puncture

or damage. Check all lines for weak or worn condi-

tions prior to use.

Never point a control valve at any portion of your

body or another person. Accidental discharge of

pressure and/or material can result in personal

injury.

Read each step of the instructions carefully. Make

sure a proper understanding is achieved before pro-

ceeding.

CAUTION

Install a 40-micron or finer filter at the inlet side of

this meter. Jammed gears, damage to components,

or inaccurate readings can occur.

Prior to meter installation, flush all contaminants by

pumping fluid through the system.

Apply thread sealant to all male pipe threads upon

installation.

Alemite, LLC

Maintenance

Release all pressure within the system prior to per-

forming any maintenance procedure.

Repairs should only be performed by a qualified person

using original repair parts.

Read each step of the instructions carefully. Make sure a

proper understanding is achieved before proceeding.

Battery Replacement

NOTE: All meter values remain in memory.

The batteries should be replaced once the battery icon appears on

the display. See Figure 1.

IMPORTANT: The meter will no longer register

should the battery icon begin to flash.

Recycle or discard the used batteries properly. Do

not burn or puncture the batteries. Toxic materials may be

emitted which can cause personal injury.

Avoid touching the flat surfaces of the new batteries. Skin

oils can cause battery deterioration. Clean any suspect bat-

tery with alcohol prior to installation.

Install the new Batteries as indicated on the bottom of the meter.

All values remain the same including the Current delivery.

Metering Gear Replacement

IMPORTANT: Install the gear with the magnets (mag-

nets upward) onto the left post of the body as shown

on Figure 2.

Install the additional gear perpendicular to the mag-

net gear. Rotate the gear assembly to ensure the gears

are properly positioned.

Changes Since Last Printing

Kit part number updated

WARNING

CAUTION

Revision (5-10)

SER 3679