Clarke woodworker CMS10 6501305 Instrucciones de uso y mantenimiento - Página 15
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Sierra Clarke woodworker CMS10 6501305. Clarke woodworker CMS10 6501305 20 páginas. 10” compound mitre saw
Imprimir página
3. Carbon Brushes Replacement
A spare pair of carbon brushes are supplied with the machine. Should it become
necessary to change these, evidenced by erratic performance, then simply
unscrew the brush holder plugs, ensuring the machine is disconnected from the
mains supply, and pull out the worn brushes. Replace with new brushes, and screw
in the plug, taking care not to cross thread it.
4. Head Adjustments
If you find that the cross cut is not entirely square, it will be necessary to adjust the
head using the 90° adjuster screw shown in Fig. 13.
To do this, slacken off the bevel locking lever, then lower the arm and lock in place
with the head locking knob.
Place a small square on the table, and bring the square up to the blade to test for
accuracy.
Should any adjustment be required, slacken off the 90° adjuster screw lock nut and
screw the adjuster in or out, as necessary, whilst holding the head firmly against the
stop. Tighten the securing nut when the head is exactly perpendicular.
Similarly should the 45° stop require adjusting, use a 45° template up against the
saw blade to set the adjuster to the correct position.
Fig.12
Fig.13
15