Clarke woodworker CMS10 6501305 운영 및 유지 관리 지침 - 페이지 15

{카테고리_이름} Clarke woodworker CMS10 6501305에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke woodworker CMS10 6501305 20 페이지. 10” compound mitre saw

3. Carbon Brushes Replacement

A spare pair of carbon brushes are supplied with the machine. Should it become

necessary to change these, evidenced by erratic performance, then simply

unscrew the brush holder plugs, ensuring the machine is disconnected from the

mains supply, and pull out the worn brushes. Replace with new brushes, and screw

in the plug, taking care not to cross thread it.

4. Head Adjustments

If you find that the cross cut is not entirely square, it will be necessary to adjust the

head using the 90° adjuster screw shown in Fig. 13.

To do this, slacken off the bevel locking lever, then lower the arm and lock in place

with the head locking knob.

Place a small square on the table, and bring the square up to the blade to test for

accuracy.

Should any adjustment be required, slacken off the 90° adjuster screw lock nut and

screw the adjuster in or out, as necessary, whilst holding the head firmly against the

stop. Tighten the securing nut when the head is exactly perpendicular.

Similarly should the 45° stop require adjusting, use a 45° template up against the

saw blade to set the adjuster to the correct position.

Fig.12

Fig.13