Clarke woodworker CMS10 6501305 운영 및 유지 관리 지침 - 페이지 13

{카테고리_이름} Clarke woodworker CMS10 6501305에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke woodworker CMS10 6501305 20 페이지. 10” compound mitre saw

MAINTENANCE

1. General

The machine is maintenance free, except for changing the saw blade when

necessary, maintaining adjustments, and ensuring that after use, you clean away

any sawdust or wood chips, with a low pressure air line or brush, paying particular

attention to the motor air vents which should be kept clear at all times.

Should the motor not function normally, it is possible that it has become clogged

with saw dust, in which case, it will be necessary to disassemble the motor in order

to clean the various components. Contact your CLARKE dealer for advice.

2. Changing the Saw Blade

IMPORTANT: Exercise extreme care when handling the saw blade. The tips are

extremely sharp, and careless handling could result in severe personal injury.

With the machine disconnected from

the mains supply, and the cutting head

in the raised position, undo and remove

the screw securing the link arm

attached to the clear plastic blade

guard, indicated in Fig.8.

3. Hold the blade guard in this position whilst

slackening off the screw, indicated,

sufficient for the cover to become

disengaged - note the slotted hole. It is not

necessary to remove the screw.

Fig.8

Fig.9

2. Move the safety lever to one side

to allow the clear plastic blade

guard to be pulled around the saw

blade as shown in Fig.9.