Clarke woodworker CMS10 6501305 Instructions d'utilisation et d'entretien - Page 13
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke woodworker CMS10 6501305. Clarke woodworker CMS10 6501305 20 pages. 10” compound mitre saw
Imprimer la page
MAINTENANCE
1. General
The machine is maintenance free, except for changing the saw blade when
necessary, maintaining adjustments, and ensuring that after use, you clean away
any sawdust or wood chips, with a low pressure air line or brush, paying particular
attention to the motor air vents which should be kept clear at all times.
Should the motor not function normally, it is possible that it has become clogged
with saw dust, in which case, it will be necessary to disassemble the motor in order
to clean the various components. Contact your CLARKE dealer for advice.
2. Changing the Saw Blade
IMPORTANT: Exercise extreme care when handling the saw blade. The tips are
extremely sharp, and careless handling could result in severe personal injury.
1.
With the machine disconnected from
the mains supply, and the cutting head
in the raised position, undo and remove
the screw securing the link arm
attached to the clear plastic blade
guard, indicated in Fig.8.
3. Hold the blade guard in this position whilst
slackening off the screw, indicated,
sufficient for the cover to become
disengaged - note the slotted hole. It is not
necessary to remove the screw.
Fig.8
Fig.9
2. Move the safety lever to one side
to allow the clear plastic blade
guard to be pulled around the saw
blade as shown in Fig.9.
13