Clarke woodworker CMS10 6501305 운영 및 유지 관리 지침 - 페이지 14

{카테고리_이름} Clarke woodworker CMS10 6501305에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke woodworker CMS10 6501305 20 페이지. 10” compound mitre saw

4. Allow the blade guard to fully reassert,

as shown in Fig.10, then unscrew and

remove the second cover screw, as

shown.

This will allow the complete blade guard

with centre hub and linkage to be

carefully pulled from the head.

5. Lower the saw head and lock in place

with the locking pin

6. With the clear plastic blade guard

removed, hold down the spindle locking

lever, arrowed in Fig. 11, and undo, but

do not remove the saw blade centre

screw, using the box spanner supplied,

by turning CLOCKWISE .i.e. The screw

has a left hand thread.

WARNING! NEVER push IN the Spindle

Locking Lever with the motor running

7. Pull out the head locking pin and allow the saw head to rise, under control, then

unscrew and remove the blade centre bolt. Finally, pull off the outer flange

followed by the saw blade.

NOTE: You should take this opportunity to thoroughly clean parts previously

inaccessible.

By removing the collar, it is possible to use blades with a 16mm bore.

8. Replace the blade, ensuring it is of the correct bore, or, where necessary a

collar is used to ensure it is a perfect fit on the shaft. Ensure also that all parts are

perfectly clean and the blades' teeth point down at the front.

Additionally, the blade MUST be rated with a maximum speed greater that

4850RPM

Please note that spare blades are available from Clarke International. Please

see your Clarke dealer.

Replace the outer flange and screw in the centre bolt, remembering it has a

left hand thread - i.e. turn anticlockwise to tighten.

9. Replace the clear plastic blade guard in reverse order to that when

disassembling.

Fig.10

Fig.11