Clarke IQ2000S Instrucciones de montaje y uso - Página 7

Navegue en línea o descargue pdf Instrucciones de montaje y uso para Calentador Clarke IQ2000S. Clarke IQ2000S 13 páginas. Infrared quartz heater

7. Fit the small tube (8) into the

socket in the control box (9) and

secure with the screw (10).

8. Clip the power cable (11) to the

clips (12).

9. Set the downwards angle of the

heater by loosening the mounting

bracket with a large x-head

screwdriver and adjusting the

angle before re-tightening.

10. Set the heater to the required height by loosening the locking ring (7) and

extending the top tube as required. Tighten the locking ring to secure.

Ensure all fittings are suitable secure before using the heater.

11. Connect the mains cable to a suitable power socket.

12. Pull the string repeatedly to cycle

through the following heat

settings;

• O = Off

• I = Low

• II = Medium

• III = High

CLEANING AND MAINTENANCE

WARNING: BEFORE CARRYING OUT ANY MAINTENANCE, ENSURE THE

HEATER IS SWITCHED OFF, IS DISCONNECTED FROM THE MAINS SUPPLY,

AND HAS BEEN GIVEN ADEQUATE TIME TO COOL DOWN.

PERIODICALLY

1. If there is any serious build up of dirt, wipe thoroughly with a damp cloth,

taking care that no moisture enters the heater.

2. Inspect the power cable for damage. Undue heat will cause the cable to

stiffen and crack in which case it should be replaced.

3. Ensure heating elements are free of dust (use compressed air to clean if

possible. (Always wear a dust mask if performing this task).

4. Refer to your Clarke dealer if the heater element needs replacing.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]