Armstrong 4030 Manual de instrucciones de instalación y funcionamiento - Página 4

Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Bomba de agua Armstrong 4030. Armstrong 4030 12 páginas. Base mounted pump
También para Armstrong 4030: Manual de instrucciones de instalación y funcionamiento (12 páginas)

Armstrong 4030 Manual de instrucciones de instalación y funcionamiento
i nstal la ti on &
o p era t i n g i n stru ction s
4
ce conformities
For declaration of Conformities, contact Armstrong.

introduction

This document contains specific information regarding
the safe installation, operating and maintenance of the
Series 4030 pumps and should be read and understood
by installing, operating and maintenance personnel. The
equipment supplied has been designed and constructed to
be safe and without risk to health and safety when properly
installed, operated and maintained. The instructions
following must be strictly adhered to. If clarification is
needed on any point please contact Armstrong quoting the
equipment serial number.
warning symbols
Safety instruction where an electrical hazard is
involved.
Safety instruction where non-compliance would
affect safety risk.
Safety instruction relating to safe operation of the
equipment. (at tention)

instructions for safe use

No installation of this equipment should take place unless
this document has been studied and understood. Handling,
transportation and installation of this equipment should only
undertaken by trained personnel with proper use of lifting
equipment. See later diagrams for lifting advice. Refer to the
pump nameplate for pump speed, pressure and temperature
limitations. The limits stated must not be exceeded without
written permission from Armstrong.
temper ature
Where under normal operating conditions the limit of
68°c / 155°f (Restricted Zone) for normal touch, or
8 0°c / 176°f (Unrestricted Zone) for unintentional touch,
may be experienced, steps should be taken to minimize
contact or warn operators/users that normal operating
conditions will be exceeded. In certain cases where the
temperature of the pumped liquid exceeds the above
stated temperature levels, pump casing temperatures may
exceed 10 0°c /2 12°f and not withstanding pump insulation
techniques appropriate measures must be taken to minimize
risk for operating personnel.
Series 4030
Base mounted pump

noise levels

For Pumping Unit Sound Pressure Levels, see Motor
Technical Data sheet (file no. 48 .11l).
stor age
Pumps not immediately placed into service, or removed from
service and stored, must be properly prepared to prevent
excessive rusting. Pump port protection plates must not be
removed until the pump is ready to connect to the piping.
Rotate the shaft periodically (At least monthly) to keep
rotating element free and bearings fully functional. For long-
term storage, the pump must be placed in a vertical position
in a dry environment. Internal rusting can be prevented by
removing the plugs at the top and bottom of the casing and
drain or air blow out all water to prevent rust buildup or the
possibility of freezing. Be sure to reinstall the plugs when the
unit is made operational. Rust proofing or packing the casing
with moisture absorbing material and covering the flanges is
acceptable. When returning to service be sure to remove the
drying agent from the pump.
uncr ating
Armstrong End Suction pumps are thoroughly inspected
before shipment to assure they meet with your order
requirements. After removing the pump from the crate, make
sure the equipment is in good order and that all components
are received as called for on the packing list. Any shortages
or damage should be reported immediately. Use extreme
care in handling the unit, placing slings and hooks carefully
so that stress will not be imposed on the pump. Never place
cable slings around the pump shaft. The eye bolts or lifting
lugs on the motor are intended for lifting only the motor and
not the complete unit.

handling

Use slings as shown in the diagram to lift the set. Do not use
the motor eyebolts to lift the pump set. See the delivery note
for the weight of the set.